台達電 mbed 新品登場 DFBM-NQ620 具備 BLE 與 NFC

台達電mbed新品登場 Delta DFBM-NQ620-EVB對應的套件包也有了: Grove Starter Kit for mbed  (Seeed真是無所不包啊…)

Delta DFBM-NQ620-EVB 包含了相容於 mbed 的 HDK mother board, 以及一片具備 CE/FCC/TELEC 與 BLE 模組的daughter board. mother board 設計上相容於 Arduino Uno R3, 因此可藉由許多能感測/控制 BLE 與 NFC tag 的擴充板都可直接使用, 方便開發各種 BLE 應用.

該模組是以 NORDICSemi nRF52832 SoC 為基礎, 因此支援了運用Keil, IAR and GCC 的標準的 Nordic Software Development Tool-chain, 還有 ARM mbed tool-chain. 該模組也支援 Delta 定義的 BLE CLI (Command Line Interface), 可讓外部主 MCU 透過 UART 來控制與設定 BLE 通訊. 執行於本模組的CLI  可處理所有 BLE 相關任務, 讓應用本身可由外部主 MCU 來執行, 藉此讓開發更 with minimal development overhead.

001

詳細規格如下

  • Delta DFBM-NQ620 BLE module daughter board
    • NORDICSemi nRF52832 with ARM® Cortex®-M4F processor
    • 32MHz embedded crystal, 32.768KHz embedded RTC
    • 512KB flash memory, 64KB SRAM,
    • Addtional 512KB SPI flash for application data storage
    • On board chip antennae for BLE and NFC tag
    • CE/FCC/TELEC and BLUETOOTH EPL certified
  • Delta DFBM-NQ620 mother board
    • USB drag and drop programming
    • USB Virtual COM port for serial terminal
    • CMSIS-DAP interface for programming and debugging
    • Accepts power through USB or external source (7V-12V)
    • Pin header for current measurement

 

發佈留言

發佈留言必須填寫的電子郵件地址不會公開。 必填欄位標示為 *